RVOSD G5-G6 instructions (work in progress...)

Discussion in 'RVOSD' started by Alex Villa, Jun 20, 2011.

  1. IMEIV

    IMEIV Well-Known Member

    Jun 26, 2011
    145
    0
    Ravenna, Italy
    Ok Thanks
     
  2. Mark O'Connor

    Mark O'Connor New Member

    Oct 15, 2017
    1
    0
    Male
    I am a complete newbie to this forum, and the RVOSD in general, though I have flown scale for decades.

    I have purchased the unit and will be fitting it to a RV Jet, however I have an elementary problem!

    When fitting the supplied wires to the RVOSD, the connectors appear to be "oversize" and seem to place undue stress on the pins to the point where the next connector looks like it will actually damage the pins (left of picture). I have attached a picture and would like to ask if others have had this issue? Many thanks in advance.

    RVOSD - Copy.jpg


    RVOSD - Copy.jpg
     
  3. IMEIV

    IMEIV Well-Known Member

    Jun 26, 2011
    145
    0
    Ravenna, Italy
    Hi,
    I have a question.... RVOSD6 with Throttle Control in Variable Mode use the Ground Speed or Pitot Speed to measure the speed ?

    thanks
     
  4. reznikvova

    reznikvova Administrator
    Staff Member

    Oct 16, 2008
    303
    1
    Uses the pitot tube if it is installed. I believe RVOSD will use GPS groundspeed if you do not have the airspeed sensor installed.
     
    IMEIV likes this.
  5. IMEIV

    IMEIV Well-Known Member

    Jun 26, 2011
    145
    0
    Ravenna, Italy
    OK thanks. I'll try and I let you know how it goes.
     
  6. IMEIV

    IMEIV Well-Known Member

    Jun 26, 2011
    145
    0
    Ravenna, Italy
    Hi,
    I have a question... I need to correct the lateral inclination of the AHI (it's a bit crooked)... there is a command in the menu that allows me to do it ?

    thanks
     
  7. IMEIV

    IMEIV Well-Known Member

    Jun 26, 2011
    145
    0
    Ravenna, Italy
    If I use the setting "Set neutral AHI" in the menĂ¹ can I adjust roll and pitch or only the pitch ?
    I need to adjust a slight bend in the roll axis.

    Please tell me.. thanks
     
  8. IMEIV

    IMEIV Well-Known Member

    Jun 26, 2011
    145
    0
    Ravenna, Italy
    It's an official forum.... Please someone can reply to our question ?

    thanks
     

Share This Page