Re-routing microphone + and - wires

O

OzFlyer

Well-Known Member
I am just wondering if I do as mentioned above, will my audio to my rv mic 'clean' up a bit. The sound is not very crisp as i thought it would be. Interference seems to overcome the motor and wind. Does anyone else get this?
At the moment I just use the power leads coming from the OSD to the vid tx. Maybe getting some interference from going through OSD. Thought I'd ask if anyone has tried.

Any other mic tips would be great help...

Thanks,
Justin
 
O

ommadawn

Well-Known Member
If you are using the RV mic, keep the mic gain pot turned to minimum. The mic is quite sensitive and works well turned right down. You can use your audio gain on monitor/goggles to amplify as required. Also use piece of sponge over the mic to minimize wind noise. Experiment with different locations for the mic as you can put it anywhere.
 
You must log in or register to reply here.
Top