Recent content by OzFlyer

  1. O

    Failsafe settings for RTH, Throttle/ Aux channel

    Have you played with the throttle trim next to the lever? You can set your rc receiver to output fail safe at either above 2.04ms or below 1.0ms using the throttle trim. Below is safer I think.
  2. O

    WP 6247.0 on OSD

    It would probably be a waypoint set. And you are flying within 1 mile. That's why it doesn't change.
  3. O

    The QueenBee, an step ahead of my Maxi-Swift

    Moving is the worst. My Cularis moved with us 4 times before I began building, Just finished tho:):) and I have my work room back. Look into mountain waves for thermals and your altitude record. Minimum 25kt wind perpendicular to a mountain range and on leeward side you sometimes get stationery...
  4. O

    The QueenBee, an step ahead of my Maxi-Swift

    How's it all going Alex? I might need to see you do another flight soon because I am getting a bit edgy.:p
  5. O

    Re-routing microphone + and - wires

    I am just wondering if I do as mentioned above, will my audio to my rv mic 'clean' up a bit. The sound is not very crisp as i thought it would be. Interference seems to overcome the motor and wind. Does anyone else get this? At the moment I just use the power leads coming from the OSD to the...
  6. O

    Anyone using the RVOSD5 with the Penguin?

    I found this http://www.GroundStationTV.com/Ground_Station_TV/Penguin_Build.html Seems to fly well also. On the right track with the space for camera under the canopy.
  7. O

    The QueenBee, an step ahead of my Maxi-Swift

    You don't need thermals my friend :) It's amazing seeing the mah counter going the other way. Did you glide all the way from 10km out to home?
  8. O

    The QueenBee, an step ahead of my Maxi-Swift

    I am sure some of the same processes involved in making clouds help us with our gliders. As written above, but in relation to this thread Convergence and convection would be what Alex is experiencing I think. Also causes thunderstorms and all the cumulus cloud in his video. His location is spot...
  9. O

    The QueenBee, an step ahead of my Maxi-Swift

    Ok, I watched it twice. Still amazing....I even forced my wife to watch.
  10. O

    The QueenBee, an step ahead of my Maxi-Swift

    Congratulations. You make us proud. +1 on antennas.;)
  11. O

    screen all black

    You know I think this problem just happened to me. Power is going to vid in and vid out pins (12v from aux or current sensor), but no video is being passed through. Both little LEDs are on. I have it packaged up and ready to go back.
  12. O

    The QueenBee, an step ahead of my Maxi-Swift

    Great work. Maybe the stalling problem was due to the propellers lack of ability to push the big mass through the air at that low density up that high. Perhaps this also caused the ahi to seem like it was not doing its job. Bigger prop and throttle control at low altitude might help.
  13. O

    Can I lengthen the Stock GPS Cable of the RVOSD?

    Sorry, can't get at h king. I thought they were something else. Good find though.
  14. O

    The QueenBee, an step ahead of my Maxi-Swift

    Looks very nice. Was this fully loaded 20000mah? Seemed to cruise well around the 9 amps. How far is the potential?? I got a good feeling bout it:D The key now is to take baby steps. Dont be impatient like me and try to get to the moon on the third flight. I have put myself behind months from...
  15. O

    Can I lengthen the Stock GPS Cable of the RVOSD?

    Great idea. I actually have those connectors from h king.:D
Top